山東永保機械從事裝載機生產及銷售行業已有多年時間，在實踐中積累了大量的工作經驗，并得到新老客戶的一致好評。由于裝載機的增壓器經常處于高速、高溫下工作，增壓器廢氣渦輪端的溫度在700-900℃,增壓器轉子以幾萬轉到二十多萬轉的高速旋轉,因此為了保證增壓器的正常工作,在使用中應注意以下幾點。
1、保持清潔
發動機長時間高速運轉后,不能立即熄火。發動機工作時,有一部分機油供給渦輪增壓器轉子軸承潤滑和用于冷卻的。正在運行的發動機突然停機后,機油壓力迅速下降為零,增壓器渦輪部分的高溫傳到中間,軸承支承殼內的熱量不能迅速帶走,而同時增壓器轉子仍在慣性作用下高速旋轉。因此，發動機熱機狀態下如果突然停機，會引起渦輪增壓器內滯留的機油過熱而損壞軸承和軸.特別要防止猛轟幾腳油門后突然熄火。
After the high-speed operation of the engine for a long time, you can not turn off immediately. When the engine work, some of the oil supply turbocharger rotor bearings for lubrication and cooling. After running the engine suddenly stopped, the oil pressure to drop rapidly to zero, the high temperature reached turbocharger middle part of the heat bearing housing can not be taken away quickly, and high-speed rotation inertia turbocharger rotor while still . Therefore, if the state of the engine heat engine suddenly stopped, causing the turbocharger oil retention overheating damage the bearings and shaft. Particularly to prevent sudden flameout Meng kicks after the throttle.　　
2、經常注意檢查增壓器的運轉情況 
在出車前、收車后,應檢查氣道各管的連接情況,防止松動、脫落而造成增壓器失效和空氣短路進入氣缸。
In front of the bus, after closing the car, check the connections of each airway tube to prevent loosening, shedding booster failure caused by a short circuit and air into the cylinder.
3、不能著車就走 
發動機發動后,特別是在冬季,應讓其怠速運轉一段時間,以便在增壓器轉子高速運轉之前讓潤滑油充分潤滑軸承，所以剛啟動后千萬不能猛轟油門,以防損壞增壓器油封。
After the engine is started, particularly in winter, to be allowed to idle for a period of time prior to the turbocharger rotor at high speed to allow sufficient oil lubricated bearings, so do not be started immediately after the throttle Meng, to prevent damage to the turbocharger seal.　
4、由于增壓器經常處于高溫下運轉,它的潤滑油管線因受高溫作用,內部機油容易有部分的結焦,這樣會造成增壓器軸承的潤滑不足而損壞。因此,潤滑油管線在運行一段時間后要進行清洗。
Due to high temperatures often in the turbocharger operation, due to its high temperature oil pipelines, oil prone to internal coke part, this will result in insufficient lubrication of the bearing turbocharger damage. Thus, oil pipeline after running for some time to be cleaned.　　
5、不能立即熄火 
發動機長時間高速運轉后,不能立即熄火。發動機工作時,有一部分機油供給渦輪增壓器轉子軸承潤滑和用于冷卻的。正在運行的發動機突然停機后,機油壓力迅速下降為零,增壓器渦輪部分的高溫傳到中間,軸承支承殼內的熱量不能迅速帶走,而同時增壓器轉子仍在慣性作用下高速旋轉,因此,發動機熱機狀態下如果突然停機,會引起渦輪增壓器內滯留的機油過熱而損壞軸承和軸.特別要防止猛轟幾腳油門后突然熄火。
After the high-speed operation of the engine for a long time, you can not turn off immediately. When the engine work, some of the oil supply turbocharger rotor bearings for lubrication and cooling. After running the engine suddenly stopped, the oil pressure to drop rapidly to zero, the high temperature reached turbocharger middle part of the heat bearing housing can not be taken away quickly, and high-speed rotation inertia turbocharger rotor while still Therefore, if the state of the engine heat engine suddenly stopped, causing the turbocharger oil retention overheating damage to the bearings and shaft. particularly to prevent sudden flameout Meng kicks after the throttle.　　

山東裝載機：http://m.greennutrition.cn/